Fixing messed up wiper jet systems, grassroots style
Suggested by GameboyRMHProblem: Seal that holds wiper jet motor in tank needs to be replaced, replacement not available
Solution: A big, fat, mighty glob of RTV (silicon gasket maker) around the part of the pump that goes into the tank. Don’t be afraid to use too much.
Problem: Spiderweb cracks in wiper jet tank.
Solution: Liberal application of electrical tape. Will hold well for years and years if the surface is pressed properly and the tape is applied with very low tension.
Problem: Clips that hold wiper jet hose in place have disintegrated
Solution: UV-resistant zip ties. If you plan to remove them and you want to do so easily, don’t do them up too tightly.
Problem: Gunky water lines / wonky jets, caused by mineral build-up.
Solution: Bleed the system through with vinegar (you should pull out the wiper jet system and reassemble it so the jets won’t hit the car) and let the vinegar sit for a few hours. Then bleed out again with distilled water and put the system back in place. Don’t use tap water in the future.
No one has posted any comments yet. Perhaps you'd like to be the first?
You'll need to log in or register to comment.