• 

  Aug. 15, 2008 1:24 a.m. m4ff3w Dork

  I can't seem to get a good signal from the VR sensor in the distributor. It should be VR+ to IGN Input and VR- does that go to ground?

  The sensor is working because I am getting spark from the ignition module (only using MS for fuel until I get the dizzy's advance locked out)

  The MS box is built as per the directions on MSExtra.com

• 

  Aug. 15, 2008 8:03 a.m. jwx New Reader

  Have you tired to adjust the VR pots yet?

  http://www.megamanual.com/ms2/vradjust.htm

• 

  Aug. 15, 2008 10:45 a.m. m4ff3w Dork

  I'll try that once I get back to the car.

• 

  Aug. 15, 2008 1:25 p.m. Paul_VR6 New Reader

  Generally you can't share a VR sensor with two system easily. It would be simpler to trigger off the coil, go to step 50b

• 

  Aug. 15, 2008 2:38 p.m. m4ff3w Dork

  My box didnt come with the opto-isolater, so I was trying to use the VR instead.

  I'll try it with the ign module removed and the VR wired directly into MS and see if I can get a crank signal. If I do, I'll lock the dizzy and fire the coil with MS.

  Thanks yall.

• 

  Aug. 15, 2008 2:53 p.m. Nashco Dork

  Did you ask on the MS Extra forum? Those guys are pretty with it...

  Bryce

• 

  Aug. 15, 2008 3:29 p.m. m4ff3w Dork

  Nashco wrote: Did you ask on the MS Extra forum? Those guys are pretty with it... Bryce

  That is where someone told me to share the VR signal with the ignition module.

• 

  Aug. 16, 2008 11:14 p.m. m4ff3w Dork

  Adjusting the pots did it.

You'll need to log in to post.